After i hold the button down to close it the sensor lights come back on.
Garage door will not go down unless i hold the button.
Press and hold the wall console button until the garage door is completey closed.
Can you hold the button down to make the door go down.
When you pressed the button did the opener lights blink at you.
If i lift my finger off the button before that point the door will stop and then i have to press the button again and the door will go back down.
Garage door won t go down most common problems when a door won t go down.
This sets the in car transmitter to be your garage door openers make transmitter but you are not done.
Check garage door for binding.
When the door is up the sensor lights are off.
Door starts down then stops before it is closed.
Something is blocking the beam either the sender or receiver is misaligned kicked.
If an operational problem exists and the garage door opener will not close the opener can be forced to close.
First check the sensor lights.
Yes there is a problem with the photoelectric eyes.
Go to topic listing.
My garage door will not close unless i hold the button down.
Check for interference from adjacent photo eye sensors of any brand.
The garage door will open fine but won t close w the remotes and will only close with the one mounted on the garage wall if i hold it down until the door has closed completely otherwise it just clicks and the light on the garage door flickers.
It just opens an inch and stops.
I have a genie intellicode.
Garage door won t close unless i keep the button pushed in archived.
Depending on the brand of garage door you have one of the sensor lights may flash dim or go out completely when the beam is interrupted.
Hold down on the buttons until the in car red light flashes rapidly.
The remote control in my car will not work at all.